This is the 3-cell 11.1V 2200mAh
3S1P LiPo Battery with Voltage Port by Apogee.
These batteries must be charged ONLY with a charger
designed to charge Lithium Polymer batteries which can apply
the "Constant Current/Constant Voltage" (CC/CV) charge technique.

FEATURES: New voltage port connector allows checking of each cell with LiPo
battery balancers
Polycarbonate pack protection
Fits the following 1/18 scale vehicles;
Associated RC18 Series (upper tray modification required)
X-Ray M18 and M18T
Trinity Itsy Bitsy Spyder
May fit other vehicles-check battery compartment dimensions
Next generation replacement for NiCd, NiMH, and Lithium Ion cells
Unique power technology offers high energy density, low weight, long
life, safe operation, and environmentally friendly chemistry

INCLUDES: One 3-cell 11.1V 2200mAh 3S1P LiPo Pack with Voltage Port by Apogee
Connector not included

REQUIRES: Charger such as the Great Planes Triton (GPMM3150), Hobbico's Accu
Cycle Elite (HCAP0280) and Quick Field Charger MkII (HCAP0290)
or Great Planes PolyCharge Lithium Polymer DC charger (GPMM3010)
IMPORTANT: Pack is charged through the main leads. The voltage port
is for cell monitoring NOT charging
Pin #1 (Red wire) on the voltage port connector is for cell 1, pin 2
(Black wire) is for cell 2 and pin 3 (Black wire) is for cell 3
To check voltage use the following diagram,
Cell 1: pins 1 (+) and 2 (-)
Cell 2: pins 2 (+) and 3 (-)
Cell 3: pins 3 (+) and 4 (-)

SPECS: Length: 4.08" (100mm)
Width: 1.43" (35mm)
Thickness: 1.06" (26mm)
Weight: 6.93oz (194g)
Wire Leads: 14 gauge silicon
Charge Rate: Charge as 3-cell at 2.2A or less
Minimum Discharge Voltage: 9.0V
Maximum Continuous Discharge Amperage: 44A (20C)
Maximum Operating Temperature: 140°F (60°C)
Maximum Charge Amperage: 1.2A (1C)
Maximum Charge Voltage: 12.6V pack

COMMENTS: NEVER charge Lithium Polymer batteries with a charger designed for
NiCd, NiMH, or any other type of battery chemistry. Use ONLY
the chargers listed under REQUIRES or equivalent substitutes.

Do not allow LiPo cells to overheat at any time. Cells which reach
greater than 140° Fahrenheit (60C) will usually become damaged and
could catch fire.
Do not charge or discharge LiPo cells on or near combustible
materials including paper, plastic, carpets, vinyl, leather, wood,
inside an R/C model or full size automobile.
Do not expose LiPo cells to water or moisture at any time.
Do not store batteries near an open flame or heater.
Do not assemble LiPo cells or pre-assembled packs together with
other LiPo cells or packs.
Do not leave a LiPo battery unattended during charging or discharging
Always store LiPo batteries in a secure location away from children
Always remove a LiPo battery if model is involved in any kind of
crash. Carefully inspect the battery and connectors for even the
smallest damage. CAUTION: cells may be hot! Do not allow the
electrolyte to get into eyes or on skin. Wash affected areas
immediately if they come into contact with electrolyte.

jxs 5/17/06
ir/jxs
updt jxs 7/23/07